Control Cable Adjustment

ADJUSTMENT
1. Move control assembly into N (Neutral) position.





NOTICE: The control cable must be disconnected from the transaxle range switch lever prior to disconnecting it from the control cable bracket. Otherwise damage to the manual shift shaft may result, requiring transaxle disassembly.

2. Using Fascia Retainer Remover tool J36346, disconnect control cable from transaxle range switch lever.
(VT25-E Shown)





3. Disconnect control cable from control cable bracket by depressing control cable retainer clip tabs and pulling up.
(AF33-5 Shown)
4. Release control cable assembly adjustment lock.





4.1. Slide black tab back.





4.2. Insert screwdriver into slot under white tab and pull up on white tab.





5. Install control cable into control cable bracket. Secure with control cable retainer clip. An audible snap will be heard when properly installed.
(VT25-E Shown)





6. Snap cable end fitting onto ball stud of transaxle range switch lever. An audible snap will be heard when properly installed.
(AF33-5 Shown)
7. Lock control cable adjustment tab.





7.1. Push down on white tab to secure in place.





7.2. Slide black tab over white tab to lock in place.
8. Verify proper operation.