Do you have access to Mitchell1 Prodemand, or eautorepair.net DIY? If you are willing to share user/password (we can pay), please get in contact with us ASAP (truly, it is urgent): email operation-charm [[at]] tuta.io or click to submit anonymously
Knock Sensor: Service and Repair
KNOCK SENSOR (KS) REPLACEMENTREMOVAL PROCEDURE
1. Remove the starter.
2. Disconnect the knock sensor (KS) harness connector.
3. Remove the KS retaining bolt.
4. Remove the KS.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
IMPORTANT: The KS threaded surfaces must be clean before installation.
1. Install the knock sensor.
Tighten the knock sensor retaining bolt to 25 N.m (18 lb ft).
2. Connect the knock sensor harness connector.
3. Install the starter.