94. Fluid Pump Installation

Fluid Pump Installation
^ Tools Required
- J 45053 Universal Clamp Press





Important: Do not drop the second coast clutch and second clutch hub and second clutch sprag assembly (11).

1. Install the second coast clutch and second clutch hub and second clutch sprag assembly (11) into the fluid pump assembly.





Notice: If dimension B is not within specifications, adjust it to within specifications or damage to the transmission may occur.

Notice: If the installed height is greater than specifications, the second coast clutch outer race assembly did not clear all the second clutch fiber plates and needs to be re-indexed to prevent a mechanical failure and/or damage.

2. Measure dimension B.
Installation Height
^ Dimension B should be 51.09 - 51.71 mm (2.011 - 2.035 inch).





3. Rotate the transmission assembly as shown.
4. Using J 45053, install the fluid pump assembly onto the input shaft. Align the bolt holes of the fluid pump body with the holes in the transmission case making sure that the second coast clutch and second clutch hub and second clutch sprag assembly remains correctly installed into the fluid pump assembly.
5. Lightly press the fluid pump body into the transmission case assembly in order to seat the fluid pump assembly in place.





Notice: Make sure that ALL of the fluid pump to case bolts (5) are 28 mm in length, and were not used in either the torque converter housing or the transmission case cover installations. Using 30 mm bolts will cause internal damage to the transmission.

6. Install the 8 - M8 x 1.25 x 28 mm fluid pump to case bolts (5) and hand tighten.





7. Rotate the transmission assembly so that the fluid pump assembly is facing up.

Notice: Refer to Fastener Notice in Service Precautions.

8. Tighten the fluid pump to case bolts in the correct sequence.
^ Tighten the fluid pump to case bolts to 19.6 - 29.4 Nm (14.5 - 21.68 ft. lbs.).