35. Cylinder Head Assemble

Cylinder Head Assemble

^ Tools Required
- J 41775 Valve Seal Installer
- J 43963 Valve Spring Compressor
- SA9102E-A Valve Seal Remover/Installer





1. Coat the valve stem with engine oil.
2. Insert the valve stem into the proper port.
3. Install the valve spring seat.
4. Use the J 41775 to insert the valve seal into the cylinder head.





5. Install the valve spring.
6. Install the cap on the valve stem.
7. Use the SA9102E-A and J 43963 to compress the valve spring.
8. Perform the following steps to install the valve stem keys:
8.1. Use a light grease to hold the keys in place while removing the SA9102E-A and J 43963.
8.2. Seat the valve stem keys in the upper groove of the valve stem.
9. Install the lifter.
10. Repeat the above sequence for the remaining valves.