Radio Replacement
RADIO REPLACEMENTREMOVAL PROCEDURE
1. Remove the I/P center trim bezel.
2. Remove the radio screws.
3. Disconnect the radio electrical connectors and the antenna.
4. Disconnect the ground strap.
5. Remove the radio.
INSTALLATION PROCEDURE
1. Position the radio in the vehicle.
2. Connect the ground strap.
3. Connect the electrical connectors and the antenna.
4. Install the radio screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 2.5 N.m (22 lb in).
5. Install the I/P center trim bezel.
6. Set up the radio.