Console Trim Panel Replacement - Left

Console Trim Panel Replacement - Left

Removal Procedure





1. Position the front seats rearward.
2. Reach under the front seats to access the lower console screws.
3. Remove the console screws.




4. Remove the cup holder liner.
5. Remove the cup holder screw.




6. Lift the rear of the center floor console.
7. Disconnect the electrical connector to the auxiliary power outlet.
8. Slide the center floor console rearward.




9. Remove the center trim panel by pulling outward.
10. Remove the console shift lever bezel. Refer to Console Shift Lever Bezel Replacement (Console Shift Lever Bezel Replacement) .




11. Remove the screws from the steering column filler panel.
12. Remove the filler panel by pulling outward.




13. Remove the screws from the left console trim panel.
14. Remove the push-in fastener from the trim panel.
15. Remove the trim panel from the vehicle.



Installation Procedure





1. Position the left console trim panel.
2. Install the push-in fastener.

Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the screws to the left console trim panel.

Tighten the screws to 2.5 N.m (22 lb in).





4. Position the steering column filler panel.
5. Install the screws to the filler panel.

Tighten the screws to 2.5 N.m (22 lb in).





6. Position the center trim plate to the front console.
7. Push until the trim clips engage.
8. Install the console shift lever bezel. Refer to Console Shift Lever Bezel Replacement (Console Shift Lever Bezel Replacement) .




9. Lift the rear of the center floor console.
10. Connect the electrical connector to the auxiliary power outlet.
11. Reposition the center console.




12. Install the cup holder screw.

Tighten the screws to 2.5 N.m (22 lb in).

13. Install the cup holder liner.




14. Reach under the front seats to access the lower console screws.
15. Install the center console screws.

Tighten the screws to 2.5 N.m (22 lb in).

16. Position the front seat forward to the original position.