Control Valve Body Cover Replacement

Control Valve Body Cover Replacement

Removal Procedure
1. Remove the battery.
2. Remove the battery tray and bracket.





3. Disconnect the transmission electrical connector.





4. Remove the transmission vent cap.
5. Remove the bolts from the control valve body cover.
6. Remove the control valve body cover.
7. Remove the control valve body cover gasket. Discard the gasket.

Installation Procedure





1. Install a NEW control valve body cover gasket on the transmission case assembly.
2. Inspect the control valve body cover for damage.
3. Install the transmission vent cap.
4. Install the control valve body cover and bolts on the transmission case assembly.





5. Connect the transmission electrical connector.






Notice: Refer to Fastener Notice in Cautions and Notices.

6. Install the valve body cover and bolts.
- Tighten the bolts in sequence to 11 Nm (97 inch lbs.).
7. Install the battery tray bracket.
8. Install the battery.