Rear Door Limiter: Service and Repair

Door Check Link Replacement - Rear

Removal Procedure


Caution: In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door pillar in the area of the side impact sensor (SIS). Turn OFF the ignition and remove the key when performing service in the area of the SIS.





1. Remove the rear door trim panel. Refer toTrim Panel Replacement - Side Rear Door Service and Repair
2. Remove the rear door lower speaker. Refer to Speaker Replacement - Rear Door in Entertainment.
3. Remove the check link bolts at the hinge pillar.




4. Remove the check link nuts from the door frame.
5. Remove the check link from the door through the speaker opening.



Installation Procedure





1. Install the check link to the door frame.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the nuts to the check link.

Tighten the nuts to 10 N.m (89 lb in).





3. Install the check link bolts.

Tighten the bolts to 10 N.m (89 lb in).

4. Install the rear door lower speaker. Refer to Speaker Replacement - Rear Door in Entertainment.
5. Install the rear door trim panel. Refer to Trim Panel Replacement - Side Rear Door Service and Repair