Coolant Heater Replacement

Coolant Heater Replacement

Removal Procedure





1. Drain the cooling system.
2. Disconnect the coolant heater power supply cord from the coolant heater.

Important: A residual amount of coolant will drain from the engine block.

3. Remove the coolant heater and washer from the engine block.

Installation Procedure





1. Install the washer to the coolant heater.

Notice: Refer to Component Fastener Tightening Notice in Service Precautions.

2. Install the coolant heater into the engine block.
^ Tighten the coolant heater to 60 Nm (44 ft. lbs.).
3. Connect the coolant heater power supply cord to the coolant heater.
4. Fill the cooling system.