Valve Rocker Arm Cover Replacement (Right)
Valve Rocker Arm Cover Replacement- RightRemoval Procedure
1. Disconnect the vacuum brake booster hose.
2. Disconnect the MAP sensor connector.
3. Disconnect the IAT sensor connector.
4. Disconnect the ECT sensor connector.
5. Disconnect the EVAP purge hose from the purge valve.
6. Remove the intake manifold.
7. Disconnect the fuel injector connectors.
8. Remove the wiring harness bracket bolt from the valve rocker arm cover.
9. Remove the ignition coils.
10. Remove the bolts (543), grommets (544), valve cover (542) and gasket (541).
11. Remove the seals (540). if required.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install NEW seals (540), NEW gasket (541), cover (542), NEW grommets (544) and bolts (543).
2. Tighten the bolts in sequence.
^ Tighten the bolts to 12 Nm (106 inch lbs.).
3. Install the ignition coils (707) and bolts (708).
^ Tighten the bolts to 12 Nm (106 inch lbs.).
4. Install the wiring harness bracket bolt to the valve rocker arm cover.
^ Tighten the bolt to 10 Nm (89 inch lbs.).
5. Connect the fuel injector connectors.
6. Install the intake manifold.
7. Connect the EVAP purge hose.
8. Connect the IAT sensor connector.
9. Connect the MAP sensor connector.
10. Connect the vacuum brake booster hose.
11. Connect the ECT sensor connector.