Oil Pick Up/Strainer: Service and Repair
Oil Pump Pipe and Screen Assembly ReplacementRemoval Procedure
1. Raise and support the vehicle.
2. Drain the engine oil.
3. Remove the oil pan.
4. Remove the oil pipe bolts.
5. Remove the oil pipe screen assembly:
6. Remove the oil pipe O-ring. Discard.
7. Clean the gasket surfaces.
Installation Procedure
1. Install a NEW oil pump pipe O-ring.
2. Install the oil pipe screen assembly.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the oil pump pipe bolts.
^ Tighten the bolts to 12 Nm (106 inch lbs.).
4. Install the oil pan.
5. Lower the vehicle.
6. Refill the engine with 4.73 L (5 qt) of oil.
7. Start the vehicle and inspect for leaks and correct oil pressure.