31. Piston, Connecting Rod, and Bearing Removal

Piston, Connecting Rod, and Bearing Removal

^ Tools Required
- J 24270 Cylinder Bore Ridge Reamer
- J 41742Connecting Rod Guide Pin





1. Rotate the engine to position the piston (120) at Bottom Dead Center (BDC) in the cylinder.





2. If a ridge of metal or hard carbon can be felt around the top of any cylinder, use the J 24270 in order to remove the cylinder ridge.





3. Remove the bolts (115), cap (116), pins (128) and lower bearing half (117).





4. Use the J 41742 in order to remove the piston and connecting rod assembly from the block.
5. Remove the upper bearing half from the connecting rod.
6. Install the cap onto the connecting rod and mark or sort the bearings for assembly.