Coil Spring Replacement

Coil Spring Replacement

Removal Procedure





1. Raise and support the vehicle.
2. Remove the tire and wheel.

Important: Hold the link with a wrench during nut removal.

3. Remove the stabilizer link to lower control arm nut.





4. Remove the trailing arm bracket to underbody bolts.





5. Place a screw-type jackstand under the lower control arm.
6. Using the jackstand, compress the coil spring.





7. Remove the lower shock bolt.





8. Loosen the lower control arm to support frame bolt.





9. Remove the lower control arm to knuckle nut and bolt.





10. Lower the control arm in order to unload the coil spring.
11. Remove the coil spring.

Installation Procedure





1. Install the spring to the lower control arm.

Important:
^ Spray silicon lubricant on the insulators to aid in installation.
^ Ensure the spring is properly seated.

2. Position the spring with the rubber insulators into the vehicle.
3. Use a screw-type jackstand to compress the spring.





Notice: Refer to Fastener Notice in Cautions and Notices.

4. Install the knuckle to the lower control arm.
^ Tighten the lower control arm to knuckle nut and bolt to 110 Nm (81 ft. lbs.).
5. Tighten the lower control arm to support nut and bolt.
^ Tighten the nut and bolt to 160 Nm (118 ft. lbs.).





6. Install the shock to the lower control arm.
^ Tighten the lower shock bolt to 110 Nm (81 ft. lbs.).
7. Remove the jackstand.





Important: Hold the link with a wrench during nut installation.

8. Install the stabilizer link to the lower control arm.
^ Tighten the nut to 15 Nm (11 ft. lbs.).





9. Push the trailing arm upward to align the front bracket to body bolt.
10. Use a drift to aid in bracket alignment and install the remaining bolts.
^ Tighten the bracket to body bolts to 110 Nm (81 ft. lbs.).
11. Install the tire and wheel.
12. Lower the vehicle.
13. Check the rear alignment.