120. Clutch Pressure Control Solenoid Cover Installation

Clutch Pressure Control Solenoid Cover Installation





1. Install 2 8 mm x 14 mm clutch pressure control solenoid cover locating pins (83) into the recessed bolt holes of the transmission case housing (31).
2. Install the clutch pressure control solenoid cover gasket (82) over the clutch pressure control solenoid cover locating pins (83).






Notice: Refer to Fastener Notice in Cautions and Notices.

3. Secure the clutch pressure control solenoid cover (84) using 7 M6 x 1.0 x 35 mm flanged bolt/screws (85) and tighten.
- Tighten the bolt/screws to 12 Nm (106 inch lbs.).