24. Torque Converter Bearing and Fluid Seal Replacement

Torque Converter Bearing and Fluid Seal Replacement

- Tools Required
- DT 46414 Driver, 62 mm x 68 mm
- DT 46417 Driver
- EN 46342 Driver Handle
- J 26941 Bushing and Bearing Remover - 3-4 in
- SA9133T Axle Seal Puller
- SA9133T- I Axle Seal Puller Adapter

Removal





1. Using the J 26941 (3), SA9133T (1) and SA9133T-1 (2), remove the torque converter seal (116) from the torque converter housing (150).
2. Using the J26941 (3), SA9133T (1) and SA9133T- 1 (2), remove the torque converter bearing (115) from the torque converter housing (150).

Installation





1. Using the DT 46414 (2) and EN 46342 (1), install the torque converter bearing (115) until it bottoms out flush in the torque converter housing (150) using the 68 mm side of the driver.






Notice: Do not install the torque converter fluid seal (116) below the flanged section of the torque converter housing or premature failure of the mainshaft front bearing could occur.

2. Using the DT 46417 and EN 46342, install the torque converter fluid seal (116) until it is flush with the flanged section of the torque converter housing (150) using the 45 mm side of the driver.