25. Output Shaft Bearing Replacement

Output Shaft Bearing Replacement

- Tools Required
- DT 46415 Driver, 45 mm x 63 mm x 78 mm
- EN 46342 Driver Handle
- J 26941 Bushing and Bearing Remover - 3-4 in
- SA9133TAxle Seal Puller
- SA9133T-1 Axle Seal Puller Adapter

Removal





1. Using the J26941 (2), SA9133T (1) and SA9133T-1, remove the output shaft front bearing (136) from the torque converter housing (150).
2. By hand, remove the output shaft lube feed plate (135) from the torque converter housing (150).
3. Inspect the output shaft front bearing (136) for wear or damage. Replace bearing if necessary.

Installation





1. Install the output shaft lube feed plate (135) into the torque converter housing (150).
2. Install the original 40.5mm x 74mm x 21 mm output shaft front bearing (136) in the direction as shown in the insert.





3. Using the 65 mm side of DT 46415 (2) and EN 46342 (1), install the output shaft front bearing (136) until it bottoms out in the torque converter housing.
When the bearing is fully seated in the torque converter housing, the upper part of the bearing will be slightly above the housing surface due to the design of the bearing.