59. Coast Clutch Stack Up Clearance Inspection

Coast Clutch Stack Up Clearance Inspection

- Tools Required
- J 28585 Snap Ring Remover





1. By hand, press down on the coast clutch backing plate (705) in order to seat the backing plate to the coast clutch piston (712).
2. Measure the coast clutch clearance between the coast clutch backing plate (705) and the top coast clutch fiber plate (706) with a feeler gage (1). Measure in at least 3 places. Use the average of the 3 measurements as the actual clearance.
- Specification 0.6-1.0 mm (0.024-0.039 inch)

Important: If the thickest coast clutch backing plate (705) is installed, but the clearance is still over the specification, replace all coast clutch steel (707) and coast fiber plates (706) and recheck the coast clutch (712) clearance.

3. If the coast clutch backing plate clearance is out of specification, replace the coast clutch steel (707) and fiber plates (706) as a set, and recheck for proper clearance.