99. 3RD Clutch Shaft Installed Height Inspection/Adjustment

3rd Clutch Shaft Installed Height Inspection/Adjustment





1. Install the 3rd clutch shaft assembly (830) into the torque converter housing (150).
2. Install the selective 26.5mm 3rd clutch shaft installed height washer (809) on the machined end of the 3rd clutch shaft (823) as shown in the insert.
3. Install both torque converter housing locating pins (1126) into the torque converter housing (150).
4. Install the torque converter housing gasket (68) into the torque converter housing (150).





5. Measure the installed height (a) of the 3rd clutch shaft assembly from the top (1) of the torque converter housing gasket (68) to the top surface (2) of the 3rd clutch shaft installed height washer (809).
Specification:
- The 3rd clutch shaft installation height is between 133.785-133.885 mm (5.2671-5.2711 inch)
6. If the measurement is out of specification, remove the 3rd clutch shaft installed height washer (809) and measure its thickness.
7. Select and install a new 3rd clutch shaft installed height washer (809), then recheck the installed height.