Output Shaft End Cover Replacement
Output Shaft End Cover ReplacementRemoval Procedure
1. Remove the left front wheel.
2. Remove the left front wheelhouse liner.
3. Remove the output shaft end cover bolts (3).
4. Remove the output shaft end cover (2) from the transmission.
5. Remove the output shaft end cover seal (1) from the transmission and discard.
Installation Procedure
1. Install a new output shaft end cover seal (1).
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the output shaft end cover (2) to the transmission.
- Tighten the output shaft end cover bolts to 12 Nm (106 inch lbs.).
3. Install the left front wheelhouse liner.
4. Install the left front wheel.