Radio/Stereo: Service and Repair

RADIO REPLACEMENT

REMOVAL PROCEDURE
1. Remove the center trim plate.




2. Remove the radio fasteners.
3. Pull the radio out slightly to access the rear of the radio.
4. Disconnect the electrical connectors, antenna, and radio ground strap spade terminal from the rear of the radio.
5. Remove the radio.

INSTALLATION PROCEDURE




1. Connect the radio ground strap spade terminal, electrical connectors, and antenna to the rear of the radio.
2. Install the radio by sliding it into the guides on the instrument panel (I/P).




3. Install the radio fasteners.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the fasteners to 2.5 Nm (22 lb in).

4. Install the center trim plate.