Radio Replacement

RADIO REPLACEMENT

Removal Procedure





1. Remove the I/P center trim bezel. Trim Bezel Replacement - Center

2. Remove the radio screws.





3. Disconnect the radio electrical connectors and the antenna.





4. Disconnect the ground strap.

5. Remove the radio.

Installation Procedure





1. Position the radio in the vehicle.

2. Connect the ground strap.





3. Connect the electrical connectors and the antenna.





4. Install the radio screws.

NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Tighten the screws to 2.5 Nm (22 lb in).

5. Install the I/P center trim bezel. Trim Bezel Replacement - Center

6. Set up the radio. Refer to Radio Setup. Service and Repair