Alternator: Service and Repair

GENERATOR REPLACEMENT

REMOVAL PROCEDURE
1. Turn the ignition OFF.

IMPORTANT: Record all pre-set radio stations.

2. Disconnect the negative battery cable.




3. Remove the air cleaner assembly.
4. Remove the accessory drive belt tensioner.
5. Install the engine support fixture.
6. Remove the front of the engine mount through bolt and raise the engine for proper clearance.




7. Disconnect the generator electrical connections.




8. Remove the generator to engine block bolts and the generator.

INSTALLATION PROCEDURE




1. Position the generator and install the top bolts finger tight.
2. Install the bottom bolts and tighten all the generator bolts.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the generator-to-engine block bolts to 44 N.m (33 lb ft).

3. Connect the electrical connections.

Tighten the B+ cable-to-generator nut to 12 N.m (106 lb in).

4. Lower the engine and tighten the engine mount through bolt.

Tighten the bolts to 110 N.m (81 lb ft).

5. Remove the engine support fixture.
6. Install the accessory drive belt tensioner.
7. Install the air cleaner assembly.
8. Connect the negative battery cable.

Tighten the battery terminal bolt to 17 N.m (13 lb ft).

9. Reprogram the radio stations