Input Speed Sensor Replacement

Input Speed Sensor Replacement

Removal Procedure
1. Raise and support the vehicle.





2. Disconnect the wiring harness from the input speed sensor.

3. Important: Do not damage the input speed sensor or transaxle case.

Remove the input speed sensor bolt/screw.
4. Remove the input speed sensor, and the input speed sensor O-ring.

Installation Procedure





1. Apply automatic transmission fluid to the new input speed sensor O-ring seal.
2. Install the new input speed sensor O-ring seal onto the input speed sensor.
3. Install the input speed sensor into the transmission case assembly.

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the input speed sensor bolt.
^ Tighten the bolt 12 Nm (106 inch lbs.).
5. Connect the wiring harness to the input speed sensor.
6. Lower the vehicle.