Operation CHARM: Car repair manuals for everyone.
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Blower Motor: Service and Repair



Blower Motor Replacement

Removal Procedure

1. Remove the right closeout panel.
2. Remove the blower motor wire harness connector.






Important: Cut through the case as straight as possible because the motor cup must be replaced. In order to prevent damage to the component, do not cut any deeper than necessary to remove the motor cup.

3. Cut out the blower motor using a utility knife in the narrow groove of the lower case.




4. Remove the blower motor.




5. Remove the blower motor nuts.
6. Remove the blower motor from the blower motor cup.

Installation Procedure




1. Install the new blower motor to the blower motor cup.

Notice: Refer to Fastener Notice.

2. Install the blower motor nuts.

Tighten the nuts to 2.4 N.m (21 lb in).




3. Install the motor blower seal to the blower motor service ring.
4. Install the blower motor.
5. Install the blower motor attachment ring.
6. Install the blower motor screws.

Tighten the screws to 1.5 N.m (13 lb in).

7. Install the blower motor wire harness connector.
8. Install the right closeout panel.