Sunroof Motor/Actuator Replacement (CF5)

Sunroof Motor/Actuator Replacement (CF5)

Removal Procedure






Important: The sunroof actuator drive shaft turns in both directions and contains no limit switches. You may replace the sunroof motor/actuator with the window panel in any position.

1. Remove the headliner.
2. Disconnect the electrical connector from the motor/actuator.




3. Remove the screws from the sunroof motor.
4. Pull straight down to disengage the drive gear from the cables housed within the sunroof cable drive tubes.
5. Remove the sunroof motor from the sunroof module.

Installation Procedure




1. Position the sunroof motor to the sunroof module.
2. Push the sunroof motor straight upward to engage the drive gear between the cables housed within the sunroof cable drive tubes.

Notice: Refer to Fastener Notice.

3. Install the sunroof actuator screws to the sunroof actuator.

Tighten the screws to 4 N.m (35 lb in).




4. Connect the electrical connector to the sunroof motor.
5. Install the headliner.
6. Initialize/teach the sunroof motor. Refer to Control Module References for programming and setup information. Programming and Relearning
7. Inspect the sunroof for proper operation.