Brake Light Switch: Adjustments

Stop Lamp Switch Adjustment




1. Remove the accelerator pedal retaining nuts. Move the pedal aside.

Notice: Proper stoplamp switch adjustment is essential. Improper stoplamp switch adjustment may cause brake drag, heat buildup and excessive brake lining wear.




2. With the brake pedal fully released, insert the stop lamp switch into the brake pedal bracket until the switch plunge is fully depressed into the barrel.
3. Twist the switch clockwise until the travel stop has been reached.




4. The plunger should extend out of the barrel (1) of the switch approximately 1.0 mm (0.04 in).






Notice: Refer to Fastener Notice.

5. Install the accelerator pedal to the dash panel. Install the retaining nuts

Tighten the accelerator pedal retaining nuts to 10 N.m (89 lb in)

6. Inspect the stop lamps for proper operation.