Rear Side Door Window Replacement

REAR SIDE DOOR WINDOW REPLACEMENT

REMOVAL PROCEDURE
1. Remove the door trim panel.
2. Remove the water deflector.
3. Remove the outer belt sealing strip.




4. Lower the window (1) to align the bolts with the access holes in the inner door panel.
5. Remove the window guide bolts (2).

6. CAUTION: Refer to Glass and Sheet Metal Handling Caution.

In order to remove the window out of the frame, carefully grasp and tilt the window as you guide the window up and forward.
7. Remove the window from the door.

INSTALLATION PROCEDURE




1. With the regulator in the remove/load position, install the window (1) to the door.
2. Tilt the window forward and carefully guide the window into the rear channel.
3. Position the window to an upright position. Ensure that the window is seated into the channels.
4. Loosely tighten the window guide bolts (2).

5. IMPORTANT: Do not operate the regulator motor without supporting the window. Ensure that the window remains in the channels when operating the regulator motor.

Carefully move the regulator upward for short slow intervals, while ensuring that the window remains in the channels.

6. Position the window (1) to a fully secure position into the upper door weatherstrip.

7. NOTE: Refer to Fastener Notice.

Tighten the 2 window guide bolts (2).

Tighten the bolts to 10 N.m (89 lb in).

8. Lower the window to the full down position.
9. Install the outer belt sealing strip.
10. Install the water deflector.
11. Install the door trim panel.