Digital Radio Receiver Replacement

Digital Radio Receiver Replacement

Removal Procedure

Important: Do not swap digital radio receivers between vehicles. Swapping digital receivers between vehicles will activate the digital radio Theftlock, "XM Theftlock" will be displayed.

1. Remove the rear seat.




2. Disconnect the electrical connector.
3. Remove the receiver fasteners.
4. Remove the receiver from the vehicle.

Installation Procedure




1. Install the receiver to the vehicle.

Notice: Refer to Fastener Notice.

2. Install the receiver fasteners.

Tighten the fasteners to 3 N.m (26 lb in).

3. Connect the electrical connector.
4. Install the rear seat.
5. Perform the setup procedure for the digital radio receiver. Refer to Control Module References for programming and setup information. Programming and Relearning