Instrument Cluster Replacement

Instrument Cluster Replacement

Removal Procedure

1. Disable the SIR system. Refer to SIR Disabling and Enabling.
2. Place the steering column in the lowest position.
3. Remove the instrument panel (I/P) cluster trim plate.




4. Remove the fasteners from the upper and the lower cluster. Pull rearward to remove the I/P cluster.
5. Disconnect the I/P cluster harness.

Installation Procedure




1. Connect the I/P cluster harness.

Notice: Refer to Fastener Notice.

2. Install the I/P cluster in the I/P housing. Install and tighten the fasteners.

Tighten the fasteners to 2 N.m (18 lb in).

3. Install the I/P cluster trim plate.
4. Enable the SIR system. Refer to SIR Disabling and Enabling.
5. Refer to Control Module References for programming and setup information.