Transmission Output Shaft Seal Replacement

Transmission Output Shaft Seal Replacement

Tools Required

* J 43068 Axle Seal Installer
* J 45000 Seal Remover

Removal Procedure

1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the drive axle assembly.
3. For right side seal, remove exhaust front pipe.




4. Using J 45000, remove the wheel drive shaft oil seal from the transmission case.

Installation Procedure





Important: The seal must install flush with the case flange.

1. Using the J 43068, install the transmission output shaft oil seal into the transmission case.
2. Install the drive axle assembly.
3. Lower the vehicle.
4. Check the transaxle fluid level.