Transmission Rear Mount Bracket Replacement

Transmission Rear Mount Bracket Replacement

Removal Procedure




1. Remove the rear transmission mount.




2. Disconnect the intermediate steering shaft from the steering gear.




3. Remove the steering gear to frame bolts.
4. Secure the steering gear upward in order to gain additional clearance.
5. Remove the HO2S sensor.




6. Remove the transmission mount bracket to transmission bolts.
7. Remove the transmission mount bracket from the vehicle.

Installation Procedure

1. Position the transmission mount bracket to the transmission.





Notice: Refer to Fastener Notice.

2. Install the transmission mount bracket to transmission bolts.

Tighten the bolts to 110 N.m (81 lb ft).

3. Install the HO2S sensor.




4. Lower the steering gear to the frame.
5. Install the steering gear to frame bolts.

Tighten the bolts to 110 N.m (81 lb ft).




6. Install the intermediate steering shaft to the steering gear.
7. Install the intermediate steering shaft to gear pinch bolt.

Tighten the bolts to 34 N.m (25 lb ft).




8. Install the rear transmission mount.