Low/Reverse Servo Assembly Replacement

Low/Reverse Servo Assembly Replacement

Removal Procedure

1. Remove the oil feed pipes.




2. Remove the 3 low and reverse band servo cover bolts, the servo and the spring.
3. Disassemble, clean and inspect the low and reverse servo assembly.

Installation Procedure

1. Assemble the low and reverse servo.





Notice: Refer to Fastener Notice.

2. Install the lo and the reverse band servo cover bolts.

Tighten the bolts to 12 N.m (106 lb in).

3. Install the oil feed pipe.

Important: It is recommended that transmission adaptive pressure (TAP) information be reset.

Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, the engine control module (ECM), powertrain control module (PCM) or transmission control module (TCM) will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.

4. Reset the TAP values. Refer to Transmission Adaptive Functions.