Clutch Pressure Control Solenoid Installation

Clutch Pressure Control Solenoid Installation





Important: Install the fluid feed pipes with the filter side of the pipe into the transmission case as shown in insert.

1. Install a 8 x 105.8 mm clutch pressure control (CPC) solenoid fluid pipe (14) into the transmission case (31).
2. Install 2 8 x 58.3 mm CPC solenoid fluid pipes (15), (19) into the transmission case (31).




3. Install the new CPC solenoid gasket (20) to the clutch pressure control solenoid manifold (84).

Important: Do not damage the O-ring seals (9) during installation.

4. Install a 7.7 x 2.3 mm fluid pipe O-ring seal (9) over each of the 3 fluid passage pipes.




5. Install the CPC solenoid valve assembly (18) onto the solenoid cover (84).
6. Install the following CPC solenoid valve bolts:
* 5 M6 x 1.0 x 25 mm bolts (17)
* A M6 x 1.0 x 55 mm bolt (16)





Notice: Refer to Fastener Notice in Service Precautions.

7. Tighten the bolts in the sequence shown.

Tighten the bolts to 12 N.m (106 lb in).