Transfer Case Input Gear Bearing Replacement

Transfer Case Input Gear Bearing Replacement

Tools Required

* DT 46415 Driver
* EN 46342 Driver Handle
* J 25070 Heat Gun
* J 26941 Bushing and Bearing Remover
* SA9133T Axle Seal Puller
* SA9133T-1 Axle Seal Puller Adapter

Removal Procedure





Notice: Do not heat the component over the specified value or damage could occur.

Important: If a slide hammer and puller are being used without heating the case, the bearing will come apart.

1. Using J 25070, heat the transmission case (31) in order to remove the transfer case input gear bearing (914).
Do not heat the transmission case greater than 100°C (212°F).
2. Using the J 26941, SA9133T-1, and the SA9133T remove the bearing after the case is warm.

Installation Procedure




1. Install the transfer case input gear 40 x 80 x 16.5 mm bearing (914) into the transmission case (31) in the direction shown in the insert.




2. Using DT 46415 (2) and EN 46342 (1), install the transfer case input gear bearing (914) until it bottoms out in the transmission case (31).