Automatic Transmission Range Selector Lever Replacement

Automatic Transmission Range Selector Lever Replacement

Tools Required

J 36346 Fascia Retainer Remover

Removal Procedure

Notice: The control cable must be disconnected from the transaxle range switch lever prior to disconnecting it from the control cable bracket. Otherwise damage to the manual shift shaft may result, requiring transaxle disassembly.

1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel.
3. Remove the left splash shield.
4. Remove the range selective lever bolt and cover.
5. Using the J 36346, disconnect the control cable from the transaxle range switch lever.




6. Remove the transaxle range switch lever nut (4), lock nut (3), washer (2), and lever (1).

Installation Procedure





Notice: Refer to Fastener Notice.

1. Install the transaxle range switch lever (1), washer (2) lock washer (3), and lever nut (4).

Tighten the transaxle range switch lever nut to 16 N.m (12 lb ft).

2. Snap the cable end fitting onto the ball stud of the transaxle range switch lever. An audible snap will be heard when properly installed.
3. Install the battery tray and bracket.
4. Install the battery.
5. Install the range selective lever bolt and cover.

Tighten the bolt to 10 N.m (89 lb in).

6. Install the left splash shield.
7. Install the tire and wheel.
8. Lower the vehicle. Refer to Vehicle Lifting.