3rd Clutch Shaft Rear Bearing Replacement

3rd Clutch Shaft Rear Bearing Replacement

Tools Required

* DT 46424 Adjustable Bearing Remover
* EN 46342 Driver Handle
* DT 46516 Driver
* SA9133T Axle Seal Puller
* SA9133T-1 Axle Seal Puller Adapter

Removal Procedure




1. Using the DT 46424 (1), SA9133T (2) and SA9133T-1 (3), remove the 3rd clutch shaft rear bearing (65) from the transmission case.
2. Inspect the bearing for wear or damage. Replace as needed.

Installation Procedure





Using the 42 mm side of DT 46516 (2) and EN 46342 (1), install the 20 x 41 x 17/16 mm 3rd clutch shaft rear bearing (65) until it bottoms in the transmission case.