Differential Case Assemble

Differential Case Assemble

Tools Required

* J 7079-2 Universal Driver Handle - Non-Threaded
* J 44386 Input/Output Bearing Installer




1. Clean all parts in a suitable solution before assembling.

Important:
* Refer to Shimming Procedures before assembling the differential case.

* Lubricate the bearing inner and outer race surface before assembly.

Install the following parts into the differential case (7):
* The pinion gears (3)
* The pinion gear thrust washers (2)
* The side gears (5)
* The side gear thrust washers (4)
* The pinion shaft (6)
* NEW snap rings (1)





Important: Apply even pressure to the vehicle speed sensor (VSS) ring during installation.

2. Install the vehicle speed sensor (VSS) ring onto the differential case.




3. Apply P/N 21005994 or equivalent to the differential ring gear bolts.

Important: The machined surface on the differential ring gear faces the differential case.

4. Install the differential ring gear onto the differential case.

Notice: Refer to Fastener Notice.

5. Install the ten NEW differential ring gear bolts.

Tighten the differential ring gear bolts to 95 N.m (68 lb ft).





Important: Refer to Shimming Procedures before installing the left differential side bearing.

6. Install a NEW left differential side bearing and shim onto the differential case using the J 44386 and the J 7079-2.





Important: Refer to Shimming Procedures before installing the right differential side bearing.

7. Install a NEW right differential side bearing and shim onto the differential case using the J 44386 (2) and the J 7079-2 (1).