Exhaust Manifold Heat Shield Replacement - Right Side

Exhaust Manifold Heat Shield Replacement - Right Side (LZ4-3.5L)

Removal Procedure





1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement (Service and Repair) .
2. Remove the connector position assurance (CPA) retainer.
3. Disconnect the engine wiring harness electrical connector (3) from the heated oxygen sensor (HO2S) electrical connector (2).
4. Remove the HO2S electrical connector rosebud clip from the engine wiring harness retainer strap (6).




5. Remove the exhaust manifold heat shield bolts (1).
6. Remove the exhaust manifold heat shield (2).



Installation Procedure






Notice: Refer to Fastener Notice (Fastener Notice) .

1. Install the exhaust manifold heat shield (2).
2. Install the exhaust manifold heat shield bolts (1).

Tighten the bolts 22 N.m (16 lb ft).





3. Connect the engine harness electrical connector (3) to the HO2S electrical connector (2).
4. Install the CPA retainer.
5. Install the HO2S electrical connector rosebud clip to the engine wiring harness retaining strap (6).
6. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement (Service and Repair) .