Engine Support Fixture

Engine Support Fixture


Tools Required
* J 28467-B Universal Engine Support Fixture
* J 28467-7A Bolt Hook
* J 28467-34 Lift Hook Wing Nut & Washer
* J-28467-13 Engine Support Fixture Adapters
* J 36462-A Engine Support Adapter Leg Set



Installation Procedure





1. Pull each end of the hood rear seal away from the cowl panel flange near both strut towers.
2. Install threeJ-28467-13 (1) and two J 28467-5 strut tower adapters (2) to the top of the left and right strut tower.
3. Install a 127 cm (50 in) engine support fixture cross barJ 28467-B (3) transversely across the vehicle between both J 28467-5 strut tower adapters (2).
4. Insert safety pins J-28467-10 (4) through the J 28467-5 strut tower adapters (2) and the cross bar (3) to prevent movement.




5. Remove air conditioning line bracket (1) from cross bar beam.




6. Position two 58 cm (23 in) engine support fixture cross bars (1) longitudinally with twoJ 36462-A leg assembly (2).
7. Install two J 28467-1A clamp (3) to secure the longitudinal mounted cross bar to the transverse mounted cross bar.




8. Assemble the lift hook wing nutJ 28467-34 , lift hook bracket J-28467-6A and lift hookJ 28467-7A to the engine lift bracket on the engine.




9. Install the lift hook and bracket assembly (1) to the longitudinal mounted cross bar (2).




10. Position theJ 28467-7A lift hook to the rear engine lift bracket.




11. Assemble the lift hook wing nutJ 28467-34 and the lift hook bracket J-28467-6A to the lift hookJ 28467-7A .




12. Install the lift hook and bracket assembly (1) to the longitudinal mounted cross bar (2).




13. Position theJ 28467-7A bolt hook (1) to the front engine lift bracket.




14. Evenly tighten both wing nutsJ 28467-34 (1) until the engine weight is supported by the engine support fixture and no longer carried by the engine mounts.