Torque Converter Seal Removal

Torque Converter Seal Removal


Tools Required
* J 41103-1 Torque Converter Seal Puller Legs
* J 41103-2 Torque Converter Seal Puller Bridge
* J 41103-3 Torque Converter Seal Support Body






1. Insert the threeJ 41103-1 puller legs under the Torque Converter Seal (54).
2. Insert theJ 41103-3 support body over the stator shaft (43).
3. Insert theJ 41103-2 puller bridge over theJ 41103-3 support body. Connect theJ 41103-1 puller legs into the slots on theJ 41103-2 bridge.

Important: The puller legs will damage the torque converter seal (54). Discard the torque converter seal (54) after removal.


4. Tighten the forcing screw on theJ 41103-2 puller bridge until theJ 41103-1 puller legs remove the torque converter seal (54).