Exhaust Manifold Heat Shield Replacement - Left Side

Exhaust Manifold Heat Shield Replacement - Left Side (LZ4) (3.5L)

Removal Procedure




1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement (Service and Repair).
2. Remove the connector position assurance (CPA) retainer.
3. Disconnect the engine wiring harness electrical connector (3) from the heated oxygen sensors (HO2S) electrical connector (2).




4. Remove the exhaust manifold heat shield bolts (1).
5. Remove the exhaust manifold heat shield (2).

Installation Procedure





Caution: Refer to Fastener Caution (Fastener Caution).

1. Install the exhaust manifold heat shield (2).
2. Install the exhaust manifold heat shield bolts (1) and tighten to 22 Nm (16 lb ft).




3. Connect the engine harness electrical connector (1) to the HO2S (2).
4. Install the CPA retainer.
5. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement (Service and Repair).