Installation

2AZ-FE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: INSTALLATION

INSTALLATION

1. INSTALL CRANKSHAFT POSITION SENSOR





(a) Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.






(b) Install the crankshaft position sensor with the bolt.
Torque: 9.0 Nm (90 kgf-cm, 80 in-lbf)
NOTE: Do not twist the O-ring.

(c) Install the wire harness and crankshaft position sensor connector clamp.
(d) Connect the crankshaft position sensor connector.
2. INSTALL GENERATOR ASSEMBLY





(a) Install the generator assembly with the 2 bolts.
Bolt A - Torque: 21 Nm (215 kgf-cm, 16 ft-lbf)
Bolt B - Torque: 52 Nm (530 kgf-cm, 38 ft-lbf)






(b) Install the generator wire to terminal B with the nut.
Torque: 9.8 Nm (100 kgf-cm, 87 in-lbf)
(c) Attach the clamp and connect the generator connector to the generator.
(d) Install the 2 wire harness clamps.
3. INSTALL FAN AND GENERATOR V BELT Installation

4. INSTALL ENGINE UNDER COVER REAR RH
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
6. INSPECT FOR OIL LEAK