Installation

SUSPENSION: FRONT STABILIZER BAR: INSTALLATION

INSTALLATION

1. INSTALL NO. 1 FRONT STABILIZER BAR BUSH (for LH Side)






(a) Install the No. 1 front stabilizer bar bush onto the front stabilizer bar as shown in the illustration.
- Install the No. 1 front stabilizer bar bush so that the dust lips face outward of the vehicle.
- Install the No. 1 front stabilizer bar bush so that the cutouts face rearward of the vehicle.

2. REMOVE NO. 1 FRONT STABILIZER BAR BUSH (for RH Side)
HINT: Perform the same procedure as for the LH side.

3. INSTALL FRONT STABILIZER BAR
(a) Install the front stabilizer bar onto the front suspension crossmember sub-assembly so that the identification mark is positioned on the right side of the vehicle.





4. INSTALL FRONT SUSPENSION MEMBER FRONT RACE LH






(a) Install the front suspension member front brace LH with the 4 bolts.
Torque: 87 Nm (887 kgf-cm, 64 ft-lbf)
- Temporarily tighten bolt A, and then fully tighten the 4 bolts in the order of B, C, D, and A.
- After installing the front suspension member front brace LH, make sure that the protrusion of the No. 1 front stabilizer bar bushing comes out.

5. INSTALL FRONT SUSPENSION MEMBER FRONT RACE RH






(a) Install the front suspension member front brace RH with the 4 bolts.
Torque: 87 Nm (887 kgf-cm, 64 ft-lbf)
- Temporarily tighten bolt A, and then fully tighten the 4 bolts in the order of B, C, D, and A.
- After installing the front suspension member front brace RH, make sure that the protrusion of the No. 1 front stabilizer bar bushing comes out.

6. TEMPORARILY INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH Installation

7. INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY Installation

8. INSTALL FRONT SUSPENSION MEMBER BRACE REAR LH Installation

9. INSTALL FRONT SUSPENSION MEMBER BRACE REAR RH
HINT: Perform the same procedure as for the LH side.

10. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT LH Installation

11. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH Installation

12. CONNECT FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH Installation

13. CONNECT FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH
HINT: Perform the same procedure as for the LH side.

14. CONNECT TIE ROD END SUB-ASSEMBLY LH Installation

15. CONNECT TIE ROD END SUB-ASSEMBLY RH
HINT: Perform the same procedure as for the LH side.

16. INSTALL FRONT STABILIZER LINK ASSEMBLY LH Installation

17. INSTALL FRONT STABILIZER LINK ASSEMBLY RH
HINT: Perform the same procedure as for the LH side.

18. CONNECT NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY Installation

19. CONNECT NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY Installation

20. INSTALL COLUMN HOLE COVER SILENCER SHEET Installation

21. INSTALL ENGINE UNDER COVER REAR RH
22. INSTALL ENGINE UNDER COVER REAR LH
23. INSTALL NO. 2 ENGINE UNDER COVER
24. INSTALL NO. 1 ENGINE UNDER COVER
25. INSTALL FRONT WHEELS
26. STABILIZE SUSPENSION Installation

27. FULLY TIGHTEN FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH Installation

28. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT Front Wheel Alignment