Front Axle Hub

AXLE: FRONT AXLE HUB: ON-VEHICLE INSPECTION

ON-VEHICLE INSPECTION

1. REMOVE FRONT WHEEL
2. SEPARATE FRONT FLEXIBLE HOSE Removal

3. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY Removal

4. REMOVE FRONT DISC Removal

5. INSPECT FRONT AXLE HUB BEARING LOOSENESS






(a) Using a dial indicator, check for looseness near the center of the axle hub.
Maximum:
0.05 mm (0.0020 in.)
NOTE: Ensure that the dial indicator is set perpendicular to the measurement surface.
HINT: If the looseness exceeds the maximum, replace the bearing.

6. INSPECT FRONT AXLE HUB RUNOUT






(a) Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.
Maximum:
0.05 mm (0.0020 in.)
NOTE: Ensure that the dial indicator is set perpendicular to the measurement surface.
HINT: If the runout exceeds the maximum, replace the axle hub.

7. INSTALL FRONT DISC Installation

8. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY Installation

9. INSTALL FRONT FLEXIBLE HOSE Installation

10. INSTALL FRONT WHEEL
Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)