Disassembly

E351 MANUAL TRANSAXLE: SHIFT AND SELECT LEVER SHAFT: DISASSEMBLY

DISASSEMBLY





1. REMOVE SHIFT AND SELECT LEVER BUSH
(a) Remove the bush from the No. 2 selecting bellcrank.






2. REMOVE NO. 1 SELECTING BELLCRANK DUST COVER
(a) Remove the dust cover from the No. 2 selecting bellcrank.
3. REMOVE SELECTING BELLCRANK SUPPORT SUB-ASSEMBLY





(a) Remove the nut, wave washer and No. 2 selecting bellcrank plate washer from the No. 2 selecting bellcrank.






(b) Remove the selecting bellcrank support from the No. 2 selecting bellcrank.






4. REMOVE NO. 2 SELECTING BELLCRANK DUST COVER
(a) Remove the dust cover from the No. 2 selecting bellcrank.






5. REMOVE NO. 2 SELECTING BELLCRANK BUSH
(a) Remove the bushes from the No. 2 selecting bellcrank.
6. REMOVE NO. 2 SHIFT LEVER INNER





(a) Hold the shift and select lever shaft in a vise with soft jaws.
NOTE: Do not damage the shift and select lever shaft.

(b) Using a 5 mm pin punch and hammer, tap out the 2 slotted pins.






(c) Apply force to the No. 2 select return compression spring, then using 2 screwdrivers and a hammer, tap out the No. 2 select spring seat shaft snap ring from the shift and select lever shaft.
(d) Remove the No. 2 select spring seat, No. 2 select return compression spring and No. 2 shift lever inner.
NOTE: Use a piece of cloth to prevent the snap ring from flying off.





(e) Remove the No. 2 select spring seat, No. 2 select return compression spring and No. 2 shift lever inner from the shift and select lever shaft.
7. REMOVE NO. 1 SELECT SPRING SEAT






(a) Remove the shift inter lock plate assembly, shift lever assembly, No. 1 select return compression spring and No. 1 select spring seat from the shift and select lever shaft.






8. REMOVE SHIFT INTER LOCK PLATE COVER
(a) Remove the shift inter lock plate cover from the shift inter lock plate.






9. REMOVE NO. 1 SHIFT LEVER INNER
(a) Remove the No. 1 shift lever inner from the shift inter lock plate.






10. REMOVE NO. 1 SELECT SPRING SEAT SHAFT SNAP RING
(a) Using 2 screwdrivers and a hammer, tap out the snap ring.
11. REMOVE SHIFT AND SELECT LEVER SHAFT DUST BOOT
(a) Remove the dust boot from the control shaft cover.
12. REMOVE CONTROL SHAFT COVER OIL SEAL






(a) Using a screwdriver, pry out the oil seal from the control shaft cover.
HINT: Tape the screwdriver tip before use to avoid damage.