Replacement

AXLE: REAR AXLE HUB BOLT: REPLACEMENT

HINT
* Use the same procedures for the RH side and LH side.
* The procedures listed below are for the LH side.

1. REMOVE REAR WHEEL

2. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY Removal

3. LOOSEN WIRE ADJUSTING NUT Removal

4. REMOVE REAR FLOOR SIDE MEMBER COVER Removal

5. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY Removal

6. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY Removal

7. REMOVE REAR DISC Removal

8. REMOVE REAR AXLE HUB BOLT

(a) Temporarily install the 2 nuts and washers onto the rear axle hub bolt as shown in the illustration.





(b) Using SST and a brass bar or an equivalent tool to hold the hub and bearing assembly, remove the rear axle hub bolt.

SST : 09611-12010

9. INSTALL REAR AXLE HUB BOLT

(a) Install a washer and nut onto a new bolt as shown in the illustration.





(b) Using a brass bar or an equivalent tool to hold the hub and bearing assembly, install the rear axle hub bolt by tightening the nut.

10. INSTALL REAR DISC Installation

11. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY Installation

12. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY Installation

13. INSPECT PARKING BRAKE LEVER TRAVEL Adjustments

14. ADJUST PARKING BRAKE LEVER TRAVEL Adjustments

15. INSTALL REAR FLOOR SIDE MEMBER COVER Installation

16. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY Installation

17. INSTALL REAR WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)