Trunk/Liftgate Sensor/Switch (For Alarm): Service and Repair

REMOVAL AND INSTALLATION

1. KEY CYLINDER LOCK/UNLOCK SWITCH AND TAMPER SWITCH

NOTE: The key cylinder lock switch, unlock switch and tamper switch are united in the switch body.

Door Switch

1. Remove door trim panel and sealing cover.
2. Disconnect connector of door key cylinder switch from door cord.
3. Remove door outer handle.

CAUTION: Be careful not to damage the door surface.




4. Remove clip, and then remove door key cylinder switch from door outer handle.
5. Installation is in the reverse order of removal.

Trunk Lid Switch (SEDAN)

1. Disconnect connector of trunk lid key cylinder switch.
2. Disconnect rod from key cylinder.
3. Remove trunk lid key cylinder switch by pushing it.
4. Installation is in the reverse order of removal.

Rear Gate Switch (WAGON)




1. Disconnect connector of rear gate key cylinder switch.
2. Disconnect rod from key cylinder.
3. Remove attaching bolts, and then remove rear gate key cylinder switch.
4. Installation is in the reverse order of removal.

2. DOOR LOCK/UNLOCK SWITCH

NOTE: The door lock/unlock switch is united with the power door lock actuator.

Driver and Passenger Door

1. Remove door trim panel and sealing cover.
2. Disconnect connector of door lock actuator assembly from door code.
3. Remove door lock actuator assembly.
4. Installation is in the reverse order of removal.

Rear Gate (WAGON)

1. Remove rear gate trim panel.
2. Disconnect rod from rear gate latch assembly.
3. Disconnect rear gate switch connector and power door lock actuator connector.
4. Remove bolts which secure power door lock actuator.
5. Remove bolts which secure latch.
6. Remove latch and actuator assembly.
7. Installation is in the reverse order of removal.

3. TRUNK LID SWITCH (SEDAN)






NOTE: The trunk lid switch is united with the trunk lid lock.

1. Remove trunk rear trim.
2. Disconnect connector of trunk switch (combined with trunk room light switch).
3. Put matching mark on the trunk lid lock and vehicle body before removal.
4. Remove bolts, then remove trunk lid lock from vehicle body.
5. Installation is in the reverse order of removal.

NOTE: Ensure that matching mark is aligned between trunk lid lock and vehicle body.

4. REAR GATE SWITCH (WAGON)






NOTE: The rear gate switch is united with the rear gate latch assembly.

1. Remove rear gate trim panel.
2. Disconnect rod from rear gate latch assembly.
3. Disconnect rear gate switch (combined with luggage room light switch) connector and power door lock actuator connector.
4. Remove bolts which secure power door lock actuator.
5. Remove bolts which secure latch.
6. Remove latch and actuator assembly.
7. Installation is in the reverse order of removal.