With Manufacturer's Scan Tool
CLEAR MEMORY MODESUBARU SELECT MONITOR
1. Select Engine MODE or A/T MODE using function key.
- Engine MODE:
Press the function key [0].
- A/T MODE:
Press the function key [/] [0] in that order.
2. Designate mode using function key.
Press [F] [C] [0] [ENT] in that order.
3. Ensure displayed message.
4. Press Junction key.
- When executing (YES)
Press [0] [ENT] in that order.
- When not executing (NO)
Press [1] [ENT] in that order.
5. When executed the indication as shown appears for approximately four seconds and the past trouble history is deleted.
6. After the display is gone, turn Subaru Select Monitor Switch and Ignition Switch to "OFF".
NOTE: When the Engine Control Module (ECM), battery terminals, etc. are disconnected after memory is cleared, idling speed may increase. This is not considered a problem because the ISC Valve duty controlled learning value has been cleared. To return the Engine to idling speed, idle for approximately 2 minutes with air conditioner "OFF".