Front Wiper and Washer

1. BLADE




1. Pull out blade following the arrow direction, from arm while pushing up locking clip.
2. Installation is in the reverse order of removal.

2. WIPER ARM
1. Open front hood.




2. Remove cap. Remove the nut which secure wiper arm, and remove wiper arm.
3. Installation is in the reverse order of removal.

NOTE: Remove metal sludge from the wiper arm fixture before installing it.

Tightening torque:
20 ± 3 N.m (2.0 ± 0.3 kg.m, 14.5 ± 2.2 ft.lb)

3. WIPER MOTOR AND LINK
1. Detach cowl panel.

NOTE: Apply silicone oil or soap water to both sides of cowl net to facilitate removal.




2. Disconnect electric connector, and remove motor attaching bolts.

Tightening torque:
5.9 ± 1.5 N.m (0.6 ± 0.15 kg.m, 4.3 ± 1.1 ft.lb)

3. Remove cowl cover.




4. Remove nut securing motor link on the back side of motor.

Tightening torque:
15 ± 3 N.m (1.5 ± 0.3 kg.m , 1.1 ± 2.2 ft.lb)




5. Remove bolts which secure sleeve unit.

Tightening torque:
5.9 ± 1.5 N.m (0.6 ± 0.15 kg.m, 4.3 ± 1.1 ft.lb)




6. Remove wiper link from service hole in front panel.
7. Installation is in the reverse order of removal.