Differential Mount: Service and Repair
A: REMOVAL1. Disconnect ground terminal from battery.
2. Move select lever or gear shift lever to "N".
3. Release the parking brake.
4. Loosen wheel nuts.
5. Jack-up vehicle and support it with sturdy racks.
6. Remove wheels.
7. Remove rear exhaust pipe and muffler.
8. Remove rear differential front member.
NOTE: When removing rear differential front member, work the removal procedure as rear differential.
B: INSTALLATION
To install, reverse the removal sequence.
1. Position front member on body by passing it under parking brake cable and securing to rear differential.
NOTE:
^ If rear differential protector has been or will be equipped, install front member, rear differential and rear differential protector as a unit.
^ When installing rear differential front member, do not confuse the installation sequence of the stopper.
2. Insert DOJ of rear drive shaft into rear differential.
CAUTION: Before inserting, replace the differential side oil seal and the circlip at the end of the spline shaft with a new one.
ST 28099PA090 SIDE OIL SEAL PROTECTOR
3. Install in the reverse order of removal.